iPad Mini Digitizer IC Connector Soldering
We would like to post a blog here about the methods of iPad Mini Digitizer IC Connector Soldering.Before soldering the iPad mini digitizer,you need prepare Tin,tape and Soldering machine.Most importantly,the IC connector should be prepared!You can remove it from old or broken digitizer or you can buy a new one.
Let's begin the process.During soldering,please be careful and take care your hands.It is dangerous.Please do not allow kids around you.
1.Peel off the tape from the new iPad Mini Digitizer Touch Screen with a Forceps or your nails.
2.Target and press the IC connector and digitizer flex cable,making them precisely aligned.Then use the tape to fasten them on the desk to make them not moving.
3.Now,we begin to soler the flex cable and IC connector.Holding the Tin with you left hand,and soldering the flex with your right hand.
During soldering,there are some Tin fragment around the flex,you can use a dishcloth to clean it.
4.After soldering,you need remove the tape.
5.Now,you can install the iPad mini digitizer and the LCD Display.There is no need to install the home button.Then turn on the device.You can check the sensitivity of the digitizer.If it works,then you can install the home button.A new iPad mini comes out.Great job!
By the way,iPad mini the digitizer with the IC Connector pre-assembled is very less in market.Most suppliers only can provide single digitizer with flex cable(no IC connector).So,no choice,we have to solder each digitizer when repairing.
However,we expect the digitizer with IC connector could come out soon.If we got in stock,we would tell you all.